Acrobat Printable Version

• Metric Socket / Wrench Set
• Floor Jack / Jack Stands

Procedure

1. Raise the vehicle on jack stands.
2. Removing the rear wheels makes the job a bit easier but is not required.
3. Remove the two bolts/nuts on either end of the sway bar that attach the sway bar to the drop links.
   

4. Remove the bolts (4 - 2 on each side) that hold the sway bar to the torque tube carrier and remove the sway bar from the vehicle.
   

5. Installation is the reverse of removal.

Clark's Garage © 1998